BT Redcare Secure Issue 16 June 2010
Installation Manual Page 18 of 40 All rights reserved
Configuring the Account Number / TAID (Optional)
The Redcare Secure unit does not require its Account Number TA ID to be entered for
normal operation, but it can be configured with the following command to aid
identification where necessary.
To set the Account Number / TA ID
* 20 * TAID # Check Digit
Example * 20 * 4191000 # 1
The unit sends a soft acceptance tone after each „#‟ and after the Check Digit. A series of sharp
beeps means data has been incorrectly entered. Re-enter the full command.
If no more parameters are to be configured, remove the header from J903 and disconnect the
DTMF phone.
Configuration Method 2. Configuration with a Web Browser
The Redcare Secure unit‟s management console is available at http://192.168.222.222/, only
when the Configuration header, J903, is shorted. If it is not possible to connect using the
Username and Password supplied during training, please contact the BT Redcare Helpline (see
Section 8).
Note that the unit does not run a DHCP server, so you must configure the PC with a static
address on the same subnet as the unit. For example, configuring the PC to have IP address
192.168.222.10 would allow connection to the unit.
Once connected, surf to the Quick Start link (see Figure 9). From here the following parameters
can be configured:
Interface combination select GP Wireless / Dial UP for Secure 2&3, or select GE Wireline /
Wireless for Secure IP (grade 4)
Panel Type This is the alarm panel protocol. This must match the protocol configured in the
alarm panel if connected to a dialler alarm panel through the dial capture port.
Line voltage monitoring. Enable / Disable the unit‟s PSTN voltage detection circuitry. (Secure
2&3 only – Line voltage monitoring is used to signal pin 955 alarms and to detect when the line is
in use by another telephone)
Line voltage alarm delay. Time to signal a PSTN Voltage Failure alarm (pin 955). Default 120
seconds. (Secure 2&3 only). Also applies to GPOP1
Line voltage restore delay. Time to signal a PSTN Voltage Failure restore (pin 955). Default 30
seconds. (Secure 2&3 only). Also applies to GPOP1
(90 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji